How do you depin a Bosch connector?

How do you depin a Bosch connector?

All you want to do is free the wire from the body of the connector. I usually cut down between each wire, then around both wires. Finally, I take the tip of the blade and pierce the heat shrink over the hole for each wire in the back of the connector.

Are all fuel injector connectors the same?

Various types of electrical connectors are used on fuel injectors, all of them have just two contacts. and most of the newer designs are waterproofed to prevent corrosion. Each will require the proper type of connector.

How do you test injector connectors?

Fuel Injector Resistance Testing

  1. Turn the multimeter to “Ohms.”
  2. Place the multimeter leads into the fuel injector plug terminal.
  3. Read the Ohms, or resistance, produced by the fuel injector.
  4. Test all the fuel injector Ohm readings.
  5. Replace the injector if the Ohm value is significantly different than other injectors.

What is a fuel injector connector?

The injector inlet connector tube (or fuel feed tube) fits in through a drilled port on the side of the cylinder head to connect the high pressure fuel lines from the pump (or rail) to the injector inlet. The Connector Tube contacts the injector to form a metal–to–metal seal.

How do you test a fuel injector plug?

Is there a positive and negative on a fuel injector?

Fuel injectors do not have negative/positive polarity. They are solenoid valves, which are polarity-insensitive. “Solenoid” is a generic term that describes a coil of wire that generates a magnetic field when electrical current runs through it.

What causes injectors not to Pulse?

So, the most likely cause, is that the fuel injectors are probably not opening. The (PCM) uses the trigger signal from the crankshaft position sensor; and/or camshaft position sensor to pulse the injectors.

Are EV6 and EV14 connectors the same?

EV6, EV14, et al refer to the body style. The injector bodies can be different but the electrical connector can be the same. Make sure you get the right length body or you will have to use spacers which isn’t a big deal.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top