Do they make a 9/16 drill bit?
9/16 in – Drill Bits – Power Tool Accessories – The Home Depot.
What size hole do you need for a 9/16 Tap?
Contact us for more information….Tap and Drill Size Chart.
THREADSIZE | DRILL DIAMETER Coarse Thread | TAP DRILLSIZE |
---|---|---|
7/16-20 | .3906 | 25/64 |
1/2-20 | .4531 | 29/64 |
9/16-18 | .5156 | 33/64 |
5/8-18 | .5781 | 37/64 |
What can I use if I don’t have a 5/16 drill bit?
5/16 converts to 10/32. Assuming your bit set is that granular, the next larger size is 11/32, and the next smallest size is 9/32. Those aren’t necessarily common sizes, however. The next size up in x/16 would be 6/16, which is 3/8.
What size is a 3/16 drill bit?
A 3/16” tapcon requires a drill bit that is measured at 5/32” in diameter.
What size is a 9/16 drill bit?
Drill Bit Hole Diameters | ||
---|---|---|
Metric Size | Fractional Size | |
25 mm | .9843 | 17/32 |
35/64 | ||
9/16 |
What size is a number 16 drill bit?
1/32″
Drill Bit Size Chart
Size | Decimal Equivalent | Size |
---|---|---|
69 | 0.0292 | 11/64″ |
.75 mm | 0.0295 | 17 |
68 | 0.031 | 4.40 mm |
1/32″ | 0.0312 | 16 |
What size is closest to 5/16 drill bit?
2583, which you then round up to the nearest drill bit size. In this case, the most relative drill bit size corresponding to the 5/16″-18 tap is 17/64, which corresponds to an F drill bit.
Which is bigger 3/8 or 5/16 drill bit?
For instance, 5/16 inches and 3/8 inches are two measurements on a ruler. In order to compare the two fractions, they must have a common denominator, 16. 3/8 is larger than 5/16.
How big is a 9/16 drill bit?
What drill bit is near 9 16?
ANSI B94. 11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments….Decimal-fraction equivalents.
fraction | in | mm |
---|---|---|
33⁄64 | 0.515625 | 13.096875 |
17⁄32 | 0.53125 | 13.49375 |
35⁄64 | 0.546875 | 13.890625 |
9⁄16 | 0.5625 | 14.2875 |