How is forestay attached to mast?
On a sailing vessel, a forestay, sometimes just called a stay, is a piece of standing rigging which keeps a mast from falling backwards. It is attached either at the very top of the mast, or in fractional rigs between about 1/8 and 1/4 from the top of the mast.
How tight should my forestay be?
If you want tight forestay for weather work, reef the main and keep it tight. There is no backstay and the raked shrouds can only do so much. A loose main sheet with a lot of twist just about insures a loose forestay.
Does the jib attach to the forestay?
Attach the tack shackle to the tang plate on the deck at the forestay. Start to attach the clips to the forestay. Start with the lowest clip, then unroll to the next. Gradually unroll the jib and attach clips, until all clips are attached.
Is Headstay same as forestay?
The headstay refers to the most forward of the stays. Its typically from the top of the mast to the most forward part of the bow. A forestay would refer to another stay that is attached a ways down from the top of the mast.
What is forestay sail?
Definition of forestaysail : the triangular aftermost headsail of a schooner, ketch, or yawl set on the forestay — see sail illustration.
What is standing rigging on a sailboat?
Standing rigging comprises the fixed lines, wires, or rods, which support each mast or bowsprit on a sailing vessel and reinforce those spars against wind loads transferred from the sails.
How tight should yacht rigging?
The caps should be tighter than with a masthead rig, with no significant slack on the leeward side when the boat’s hard on the wind and heeling 15-20°. If the static tension is up to 25% but the leeward cap is always slack, the boat might be bending.
How tight should shrouds be on sailboat?
First, straighten the mast using the outer shrouds. To tune, outer shrouds should be a few turns past hand tight, inner shrouds should be hand tight, not slack, but not tense either.
What is a staysail on a sailboat?
A staysail (“stays’l”) is a fore-and-aft rigged sail whose luff can be affixed to a stay running forward (and most often but not always downwards) from a mast to the deck, the bowsprit, or to another mast (the mast is item 13 in the illustration right).
What is the Headstay on a sailboat?
Forestay (1 or HS) – The forestay, or headstay, connects the mast to the front (bow) of the boat and keeps your mast from falling aft. Your forestay can be full length (masthead to deck) or fractional (1/8 to 1/4 from the top of the mast to the deck).
What is an inner forestay?
The inner forestay is typically attached to the mast at the upper spreader and, if not attached permanently, lives next to the mast when not in use. It is made fast to its deck fitting and can be tensioned in a variety of ways.
How much does it cost to re rig a sailboat?
For an average 40-foot boat, Cockerill estimates about $100 per foot to re-rig with wire rigging ($4,000), as well as the round-trip cost to haul and launch the boat and unstep and step the rig (an additional $2,500 or so).