What kind of transmission fluid does a GMC Jimmy take?

What kind of transmission fluid does a GMC Jimmy take?

DEXRON®-VI ATF
Valvoline – DEXRON®-VI ATF Full Synthetic Automatic Transmission Fluid, 1 Quart (Part No. 822405)

What kind of transmission fluid does a 93 GMC take?

Dexron VI
Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.

What kind of transmission fluid does 93 s10 take?

Valvoline Transmission Fluid Dexron/Mercon 1 Gallon.

What kind of transmission fluid does a 1995 GMC Jimmy take?

Castrol – Transmax ATF DEXRON®-VI Automatic Transmission Fluid 1 Quart (Part No.

What kind of transmission fluid does a 2001 GMC Jimmy take?

DEXRON®-VI
Castrol – Transmax ATF DEXRON®-VI Automatic Transmission Fluid 1 Quart (Part No. 15B1A0)

How much transmission fluid does a 1990 GMC Sierra take?

10.6 quarts 4.3 quarts
For Automatic Transmission: THM400….AF6

Notes: This specification has been updated from Dexron II or III to Dexron VI per a Technical Service Bulletin from the manufacturer
Capacity: 3 speed THM400 Total Fill 10.6 quarts 4.3 quarts Initial Fill

What fluid does a 4l60e transfer case take?

The recommeded transmission fluid for the GM 4l60e is Dexron 3 / Dexron 6 / Dex Merc. Since its release in 1993, Dexron 3 (Dex III) was the recommended transmission fluid for the 4l60e. Overtime however, Dex III was phased out and GM released Dex VI in 2005.

How many quarts of transmission fluid does a 1993 Sierra take?

For Automatic Transmission: 4L80-E….AF6

Notes: This specification has been updated from Dexron II or III to Dexron VI per a Technical Service Bulletin from the manufacturer
Capacity: 4 speed 4L80-E Total Fill 13.5 quarts 5 quarts Initial Fill

How many quarts of transmission fluid does a GMC Sierra take?

A 2014 GMC Sierra 1500 transmission flush again uses about 10 quarts of fluid to utterly clean and flush out the system.

How many quarts does a 4l60e take?

If you are have a “shallow” pan, you will most likely take 4-5 quarts, whereas a deep pan will take 5-6 quarts. Start by putting in 3 or 4 quarts first then start the vehicle. You should notice some transmission fluid on the dipstick.

What kind of fluid do I use for my transfer case?

automatic transmission fluid (ATF)
Transfer cases may be filled with gear oil, automatic transmission fluid (ATF), or specialty lubricants. It is important to regularly inspect the transfer case for any damage, leaks, or other concerns.

How much transmission fluid do I need for a GMC Sierra?

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top